for Radar/Chartplotter & System NavPods
 |
|
|
GP140 mounted on SK100 |
RP190 mounted on SK145 |
The SK100 is for mounting Instrument NavPods on this 1” stainless steel tubing. Pre-drilled and includes mounting feet. This sturdy mount is great for extending the available dash on powerboats. 3/4” inside diameter wire or connector clearance.
The SK145 allows you to better position the display for multiple viewing angles. However, the single mounting foot limits the available room for wires and some larger diameter Radar cables won’t fit through the base.
The SK135 PowerMount with two tubes allowing more than twice the room for wires may be a better choice if you don’t require the tilt and swivel features of the SK145. The SK135 mounted onto a solid dash makes for an extremely sturdy mount. Cables and connectors up to 1” can be fed through each tube. If larger diameter clearance is needed, try one of the PowerPods with 20/40 swivel base that allows up to 1.875” clearance.
For overhead or dash mounting of System NavPods, use the sturdy SK135 PowerMount Stanchion Kit. Stainless Steel tubes can be cut down if needed to maximize overhead clearance and reattached to the cast stainless steel feet with the set screws and allen wrench included.
All NavPods Feature...
Watertight Silicone Seal
Keeps rain and salt water spray off electrical connection on the back of electronics
Tamperproof
Special fasteners and wrench are included that provide security and convenience to
leave electronics on-board.
Concealed Wiring
No loose wires are exposed to corrosion and UV damage.
Clean Installation
The clean look of flush mounting. Mount your display where you can best see and
reach it.
Pre-Cut Models
Comes with a Flush Mount Kit, which includes the specific gasket and mounting
hardware for your electronics if not supplied by manufacturer with the unit.
| Item # |
Product Description |
Inches |
Centimeters |
| |
PowerMount Stanchion Kit |
w |
h |
d |
w |
h |
d |
| SK100 |
Stanchion Kit - one 1" diameter U-shaped tube, polished and pre-drilled, 12"H includes SS feet (for use with any 3 or 4 Instrument NavPod with 9.5” wide indents in back for mounting). |
8.5 |
11.5 |
6.0 |
21.59 |
29.21 |
15.24 |
| SK135 |
Stanchion Kit - two 1.25” diameter tubes, 15” H, each with one 20-degree bend, includes SS feet (for use with most Radar/Chartplotter and System NavPods with 9.5” wide indents for mounting. (Does not fit RP41series of NavPods) |
8.5 |
11.5 |
6.0 |
21.59 |
29.21 |
15.24 |
| SK145 |
Stanchion Kit - Y=shaped 1.25” diameter tube assembly, 15” H, Tilts and Swivels, includes SS foot (for use with most Radar/Chartplotter and System NavPods with 9.5” wide indents for mounting. (Does not fit RP41series of NavPods) |
8.5 |
11.5 |
6.0 |
21.59 |
29.21 |
15.24 |